White, rock the passengers seat forward, if you have a document box there, then you have to remove the lower 2 screws and the back runner board to get at two more on its top all together 4, remove one more clip/screwfrom the the side molding (where the seat belt goes into) then pull the molding off its just held in place by clips. Peel back the carpet and there is the ECU. Three bolts will have it it your hands, then remove the connectors.. I hope that's clear enough
Well I've been driving it for a couple of days now and its great. The car feels a lot faster and like it has more tourque. It just pulls better,anyway I think its money well spent.
Originally posted by jurek Hi I can rev to red line its only the speed that is limited ?? I have no chip !!!
Does this make sence??
Thats the same as mine, I redline it a few times by mistake at Santa Pod (d'oh) before it was chipped, i definatley did not have a rev limiter... I know this because my tail pipe fell off when I missed 5th gear once and redline it all the way to 10,000rpm d'oh
The rev limit only works when revs go up, on change down through the gears it is possible to over rev the engine. This is when most engine blow ups occur.
Thats what I tought when I first heard about the chip but I've tried to take it pass the 10,000 rpm mark without luck. I think the rev delimiting only happens at 140kmph and that definatly has been taken off.
Registered User
Posting Permissions
Reply With Quote
