PDA

View Full Version : Catalytic converter sensor



steveinjapan
14-04-2018, 04:50 PM
My catalyst heat light comes on intermittently, even when cold. Car is running fine. I suspect the sensor in the cat, so where can I conveniently disconnect the lead? The armored cable seems to pass up into the chassis above the catalyst. I'd rather not open the cluster if I don't have to. Thanks,
Steve

mikei
15-04-2018, 10:28 AM
hi steve
if you jack up car and take nsr wheel off you will be able to see the wiring loom as it goes up inner chassis leg
about a foot up there are two multiplugs the smaller one (single wire )can be disconnected and earthed out
(larger one is for oxygen sensor )
there is a convenient 10 mm bolt that allows you to make the connection
all you need is a piece of wire and a few connectors
this way it can be reinstated at a later if needed

good luck mikei

steveinjapan
17-04-2018, 03:03 PM
hi steve
if you jack up car and take nsr wheel off you will be able to see the wiring loom as it goes up inner chassis leg
about a foot up there are two multiplugs the smaller one (single wire )can be disconnected and earthed out
(larger one is for oxygen sensor )
there is a convenient 10 mm bolt that allows you to make the connection
all you need is a piece of wire and a few connectors
this way it can be reinstated at a later if needed

good luck mikei

Many thanks Mike. I'll get on it tomorrow.
Steve